Request Literature
|
 |
ATi
is pleased to announce the 4000 Series Transducer Signal
Conditioner. The unit features a High-Speed Analog Output
that is not found on most of the microprocessor based conditioners that
are available. The cost competitive device is packaged in a desktop
style enclosure.
|
Model
4040SC Strain Gage Signal Conditioner
|
The
4040SC
model has has
a Front Panel Shunt Calibration Switch and is compatible with Quarter,
Half and Full Bridge strain gage circuits as well as, most strain gage
based transducers including load cells, torque transducers and pressure
transducers.
Millivolt output transducers up to ±1 volt can be used with
the 4041SC-L
model. The 4041SC-H
model is for any voltage output transducer with any range up to
±10 volts. All three of the above models include a 5 volt DC
excitation supply.
The 4042SC
conditioner is designed to be compatible with most ICP type
accelerometers and includes a 1 mA constant current supply. Temperature
measurements can be input to the 4043SC
for type J or K thermocouples the 4044SC
for thermistors or the 4045SC
for 3-wire 100 ohm platinum
RTDs.
The 4046SC
can be used with 0 to 20 or 4 to 20milliamp output type transducer and
has a built-in 24 volt DC current loop power source.
A variety of analog output options are offered including 0-2, 0-5,
0-10, ±2, ±5 or ±10 volts and, 0-20 or
4-20 mA. User specified, custom filter cutoff frequencies are also
available on request. |
| FEATURES |
| High
Speed Analog Outputs!
|
| Coarse
and Fine
controls for Zero and Span.
|
| User
Selectable Filter
Cutoff Frequency.
|
| 8
Pole Analog Output Filter
|
| 120
VAC or 12VDC
operation.
|
| Internal
Excitation Supply
|
| Variety
of Analog Output
Options.
|
| Compatible
with most any
Sensor Type.
|
|
Compatible with
most strain gage based transducers including load
cells, torque transducers and pressure transducers.
Also Compatible with Millivolt, Volt and Milliamp Output Transducers,
as well as Thermocouples, Thermistors, RTDs and Accelerometers.
|
|
